PAUSE
ENCORE
BOX
LESSON REVIEW
QPR1
00 AM 4/1/89.
Remember, the arguments for the command are MMDDHHMM[YY]
00 AM 4/1/89.
Remember, the arguments for the command are YYMMDDHHMM
QPR2
2. If you have only one disk drive and you want to copy a
floppy disk, you must copy the floppy onto your hard disk,
insert an new formatted floppy disk and copy from the hard
disk onto the new floppy. Which command would you use to
do your copying?
QPR3
3. If you want to copy a dump tape with fixed record length
and you have two tape drives, which command should you use
to do your copying?
QPR4
4. When you partition a disk, each region on the disk
will correspond to one of the device entries in the
__________ directory.
QPR5
5. Which of the following steps is NOT part of the procedure
for creating file systems on a disk?
a Format the disk to subdivide it and locate bad blocks.
b Create the partition table on the disk to specify the
starting blocks and the sizes of the possible file systems.
c Make a special device file for each intended file system
in the /dev directory.
d Use the fsck command.
QPR6
6. Enter the command to format your hard disk.
(NOTE: This is not done very often; the command
should be used with caution.)
QPR7
7. Assume that the disk is formatted. The command to create
a partition or file system is:
a /etc/dkpart
b /etc/dkmaint
c /etc/divvy
d diag
e mount
QPR8
8. Assume that one of the following has occurred:
* new devices were added to the system,
* devices were moved from one controller to another, or
* some devices were removed from the system.
The most likely action that you should take is:
a reformat the hard disk
b go through the system setup/reconfiguration procedure
c call your salesman
d no action necessary
QPR9
9. Before you rebuild your kernel, you have to modify your
system configuration file in the ____________ directory.
QPR10
RINTER
______________________________________________________________________________
$PRMT_STR$
That is correct!
You've got it on the 2nd try.
Good, you understand the concept.
$F_DIAG_L1$
$F_DIAG_L2$
$F_DIAG_L3$
$S_DIAG_L1$
$S_DIAG_L2$
$S_DIAG_L3$
$REV_STR1$
FORGET1
The correct answer is: $ANSWER$
GO